| Cutting workflow | A digital pattern is prepared in CAD or nesting software, sent to the machine controller, and followed by the cutting head. The workpiece is positioned, held in place, cut, and unloaded. | Confirm which file formats, pattern-editing tools, and operator steps are supported. |
| Rubber material and product | Rubber may be supplied as sheet, roll, gasket stock, or foam. Natural rubber, synthetic rubber, and rubber composites can behave differently during cutting. | Test the actual compound, hardness, reinforcement, surface, and finished-part geometry—not just a similar-looking sample. |
| Cutting technology | Oscillating or drag knives cut by moving a blade through the material; rotary knives use a rotating blade; die cutters press a shaped tool through the stock. Waterjet systems cut with a high-pressure water stream. | Match the method to material thickness, edge quality, part shape, production volume, tooling cost, and any restrictions on water or debris. |
| Material thickness and cutting depth | Maximum thickness depends on the cutting method, blade or tool, machine configuration, and material properties. Compressed or layered stock may cut differently from a single sheet. | Request a test cut at the thickest intended material and verify that the cut passes through without excessive edge distortion. |
| Workholding and feeding | A vacuum table can hold suitable sheet material flat. Roll-fed systems advance continuous stock, while clamps or other fixtures can secure parts that are not suitable for vacuum hold-down. | Check whether the material is porous, textured, or flexible, and whether the machine can prevent slipping, stretching, or wrinkling. |
| Cutting area and nesting | The usable table or feed width limits the size and layout of jobs. Nesting software arranges parts on the sheet or roll to reduce unused material. | Measure the largest stock and part, then allow for margins, clamps, loading space, and required material grain or orientation. |
| Accuracy and repeatability | Positioning performance is influenced by the drive system, calibration, tool condition, material movement, and cutting parameters. Accuracy specifications are machine- and application-dependent. | Ask for measured results on your rubber and part design, and distinguish machine positioning specifications from finished-part tolerances. |
| Production speed and automation | Cycle time includes loading, cutting, tool changes, unloading, and inspection. Automatic feeding and nesting can reduce manual handling, but do not guarantee a particular output rate. | Run a timed trial using representative parts, including setup and handling time, before estimating daily capacity. |
| Tooling and maintenance | Blades and dies wear and require inspection or replacement. Cutting quality can also depend on tool alignment, table condition, cleaning, and preventive maintenance. | Compare tool availability and cost, changeover time, maintenance requirements, and access to technical support and training. |
| Safety and workspace | Automated cutters may use moving heads, sharp tools, or high-pressure systems. Required guarding and operating procedures depend on the machine design and cutting method. | Review guarding, emergency stops, operator training, electrical requirements, and any ventilation or waste-handling needs specified for the process. |
| Best-fit decision | A knife-based CNC system can suit flexible sheet parts and changing designs; a die cutter can suit repeat runs with a fixed shape; other methods may suit specific material or edge requirements. | Choose only after comparing sample-cut quality, total operating cost, achievable output, material waste, and fit with the production workflow. |