| Fine abrasive material with low impact, such as sand, grain, or dry powder | Approximately 450–500 HBW | 6–12 mm | Flat or lightly formed plate liners | A harder surface can improve sliding-abrasion resistance. Confirm that the supporting structure can carry the liner and fasteners. |
| General-purpose wear with moderate impact, such as aggregate chutes and truck bodies | Approximately 400–450 HBW | 8–16 mm | Flat plates or formed liners with replaceable sections | A balanced choice for wear and toughness. Thickness depends on impact energy, material flow, and expected service life. |
| Coarse rock or ore with frequent, heavy impact | Approximately 400–450 HBW | 12–25 mm | Thicker plate, supported panels, or segmented liners | Prioritize toughness and secure support. Higher hardness is not automatically better where severe impact may cause cracking or damage. |
| Severe sliding abrasion with limited impact, such as transfer points handling abrasive fines | Approximately 500–550 HBW | 6–12 mm | Replaceable flat or formed wear panels | Use only when impact is controlled and fabrication requirements are compatible with the plate supplier’s guidance. |
| Wet slurry or damp abrasive material | Approximately 400–500 HBW, selected for impact level | 8–20 mm | Smooth, well-supported panels with sealed joints where practical | Wear-resistant plate is not necessarily corrosion-resistant. Assess slurry chemistry and consider a separate corrosion-control solution if needed. |
| Chutes, hoppers, and bins with localized wear or difficult access | Approximately 400–500 HBW, based on impact and abrasion | 8–16 mm | Modular or bolted wear tiles and panels | Smaller replaceable sections can simplify maintenance. Design joints and fasteners to avoid material snagging and premature edge wear. |
| Repeated forming or complex liner shapes | Typically around 400 HBW; verify the specific product’s forming limits | 6–12 mm, subject to bend radius and process | Formed plate or segmented assemblies | Bending limits depend on thickness, hardness, plate direction, tooling, and edge preparation. Obtain product-specific fabrication instructions. |