| Clean, cool water or other low-viscosity, non-hazardous liquid | Single, balanced cartridge seal with faces and elastomers compatible with the liquid | A balanced design can reduce hydraulic closing force on the seal faces. A single arrangement is commonly considered when limited leakage to the surrounding area is acceptable. | Confirm suction conditions, seal-chamber pressure, face pairing, elastomer compatibility, and whether the pump provides adequate circulation or flushing. |
| Hot process liquid or a service with elevated seal-chamber temperature | Single cartridge seal selected for the actual temperature, with an appropriate flush or cooling arrangement where required | Temperature affects face lubrication, elastomer performance, and fluid behavior. Managing heat at the seal chamber can help maintain the conditions required for reliable operation. | Check the maximum and normal temperatures, vapor pressure, elastomer temperature limits, face-material limits, and the required piping plan and utility availability. |
| Liquid containing suspended solids or abrasive particles | Single cartridge seal with a face and chamber arrangement intended for solids-bearing service; consider a suitable clean flush if the process allows it | Solids can interfere with the lubricating film and wear seal faces. The appropriate design depends on particle size, concentration, hardness, and whether solids can settle in the seal chamber. | Identify solids concentration and particle characteristics; check chamber geometry, flush source and flow, face materials, and whether a different seal arrangement is required. |
| Viscous, polymerizing, crystallizing, or otherwise prone-to-deposit liquid | Single cartridge seal with a seal-chamber and piping arrangement suited to the fluid; evaluate circulation, heating, or flushing needs | Deposits or poor circulation can obstruct the seal area and compromise face lubrication. Cartridge construction can simplify installation, but does not by itself prevent fouling. | Review viscosity across the operating temperature range, crystallization or curing behavior, cleanability, flush compatibility, and startup and shutdown procedures. |
| Corrosive liquid | Single cartridge seal using corrosion-compatible wetted metal parts, faces, and secondary seals | Material compatibility must be assessed for every wetted component, not just the seal faces. Chemical concentration and temperature can change corrosion behavior. | Verify the full chemical composition, concentration, temperature, contaminants, and exposure conditions against material compatibility data. |
| ANSI process pump with a standard seal chamber | Cartridge seal designed for the pump’s seal-chamber dimensions and shaft or sleeve interface | A pump-specific fit helps ensure correct installation and alignment. “Cartridge” describes an assembled seal unit; it does not guarantee that a seal fits every pump of the same general type. | Confirm pump model, chamber dimensions, shaft or sleeve size, gland bolt pattern, working length, and available axial clearance. |
| Between-bearings or multistage pump | Cartridge seal engineered for the pump’s actual chamber pressure, shaft movement, and operating conditions | Seal-chamber conditions can differ substantially from discharge pressure, especially in multistage or balance-line configurations. | Obtain seal-chamber pressure, shaft runout and movement, speed, temperature, and hydraulic operating range; verify the design with the pump supplier. |
| Hazardous, toxic, or environmentally regulated liquid | Do not assume a single seal is sufficient; assess whether a dual seal or another containment system is required | A single seal has one primary sealing interface and may allow leakage. The acceptable arrangement depends on the hazard, emissions limits, regulations, and site risk assessment. | Review applicable regulations and process-safety requirements, expected leakage consequences, monitoring needs, and the site’s containment strategy. |