| Typical service-temperature span | Approximately −60°C to 200°C for many general-purpose VMQ compounds | Treat this as a general range, not a guarantee for every grade or continuous-duty application. Request limits for the actual compound and part. |
| Low-temperature flexibility | Many VMQ grades remain flexible at temperatures near −60°C | Ask for low-temperature test data relevant to the application, such as brittleness or flexibility testing, and consider seal geometry and compression. |
| Moderate-temperature service | Applications from ambient temperature through approximately 150°C are common, subject to grade and exposure | Evaluate compression set, contact media, pressure, and expected service life rather than relying on temperature alone. |
| Upper end of typical service | Some VMQ compounds are specified for service up to approximately 200°C | Confirm whether the stated limit applies to continuous exposure, intermittent exposure, or a particular test method. Heat aging can affect strength and elasticity. |
| Hardness selection | Common commercial VMQ options span roughly 30–80 Shore A, depending on formulation | Match hardness to sealing force, deformation, and assembly needs. Compare results using the same test method and specimen conditions. |
| Mechanical properties | Tensile strength and elongation vary substantially with compound formulation, hardness, and test method | Request compound-specific test reports. Do not use generic values as acceptance limits for a production part. |
| Heat and weather resistance | VMQ is commonly selected for resistance to heat, ozone, and outdoor weathering | Check heat-aging and environmental test results for the required duration and conditions. |
| Fluid compatibility | Compatibility depends on the fluid, temperature, and specific VMQ formulation; VMQ is generally not a first-choice material for many fuels, oils, and hydrocarbon fluids | Test swelling, hardness change, and mechanical-property retention in the actual fluid. Verify suitability separately for steam or hot-water exposure. |
| Supplier documentation | Documentation should identify the compound grade, test methods, and reported results | Request a current technical data sheet, safety data sheet, batch traceability details, and applicable regulatory declarations for the destination market. |
| Part validation | A compound’s laboratory rating does not establish the performance of every finished component | Validate the molded or extruded part under representative temperature, media, pressure, and aging conditions before production approval. |