| 1. Chromium coating system | Engineering hard-chromium plating; coating specification defined by the component drawing | ISO 6158, electrodeposited chromium coatings for engineering purposes | ISO 6158 provides requirements and guidance for engineering chromium coatings; it does not establish one coating thickness suitable for every piston rod. |
| 2. Coating microhardness | 800–1,100 HV is a commonly cited target range for hard-chromium coatings | Vickers testing: ISO 6507-1 | Report the test load, indentation location, coating thickness, and test method. Results can vary with plating chemistry and process conditions. |
| 3. Surface roughness | Ra ≤0.2 μm as a common finish target for seal-running surfaces | Profile surface-texture specification and measurement: ISO 21920 series | Specify the evaluation length, filtering, measurement direction, and sampling plan alongside Ra. A drawing may require a different finish for a particular seal system. |
| 4. Coating thickness | Application-specific; 20–50 μm is a commonly encountered engineering range, not a universal limit | ISO 6158 and the component drawing | Thickness selection depends on corrosion exposure, wear allowance, dimensional tolerance, and whether the rod is new or refurbished. |
| 5. Coating adhesion | No lifting, peeling, or flaking under the agreed inspection and acceptance procedure | ISO 2819 describes adhesion tests for electrodeposited and chemically deposited metallic coatings | Select a suitable test method and acceptance criteria for the coating, substrate, and part geometry; record the method used. |
| 6. Substrate material | Steel grade selected for strength, hardenability, machinability, and service conditions; 42CrMo4 / 4140 are examples used in engineering applications | Material grade and heat-treatment condition specified on the drawing or purchase specification | These are examples, not mandatory grades. Verify the applicable material standard, delivery condition, and material certificate for each order. |
| 7. Corrosion resistance qualification | Test method, exposure duration, and acceptance criteria agreed for the intended environment | ISO 9227 provides neutral salt-spray, acetic acid salt-spray, and copper-accelerated acetic acid salt-spray test methods | ISO 9227 defines test procedures, not a universal service-life prediction or a single pass duration for all piston rods. |
| 8. Diameter and dimensional tolerance | Tolerance stated on the part drawing and coordinated with the seal and guide design | ISO 286 series for limits and fits, where applicable | A general fit class should not replace the specified rod diameter tolerance, coating allowance, or post-plating finishing requirement. |
| 9. Straightness and runout | Limits defined by rod diameter, unsupported length, assembly design, and purchaser drawing | Drawing-defined geometric tolerances and an agreed inspection method | There is no single straightness value suitable for every rod length and diameter. State the measurement span, support condition, and acceptance limit. |
| 10. Traceability and inspection records | Lot-level identification with material, heat-treatment, coating, dimensional, and surface-finish records as required by the order | Purchaser quality plan and documented inspection requirements | Request certificates and inspection reports appropriate to the application; the required record set should be agreed before production. |