| Meaning of “8K” | Confirm that “8K” refers to a mirror-polished stainless steel finish, commonly called a No. 8 or mirror finish—not a steel grade or a universally defined roughness value. | State the required mirror appearance, viewing conditions, and approved sample in the purchase specification. | Compare the delivered plate with an approved sample under consistent lighting. Finish terminology and appearance can vary between suppliers. |
| Stainless steel grade | Choose the alloy for the service environment. Type 304 is commonly used for general indoor applications; Type 316 contains molybdenum and is often selected for more demanding chloride exposure. | For example, specify Type 304 or Type 316 to the applicable product standard. Typical ASTM composition limits include 18–20% chromium and 8–10.5% nickel for 304; 16–18% chromium, 10–14% nickel, and 2–3% molybdenum for 316. | Request a material test certificate (MTC). Positive material identification (PMI), such as X-ray fluorescence, can help check alloying elements; it does not measure carbon reliably. |
| Product form and standard | Verify that the material is plate or sheet in the required form, rather than a different product category, and that the governing standard is stated. | Specify the applicable standard and edition—for example, ASTM A240/A240M for stainless steel plate, sheet, and strip—or the relevant regional standard. | Check the order, markings, and MTC for the grade, product form, standard, and heat or lot identification. |
| Thickness and tolerances | Confirm the nominal thickness, agreed tolerance, and whether the measurement applies before or after polishing. | Example: 1.5 mm nominal thickness, with tolerances defined by the applicable standard and purchase agreement. | Measure at several points using a calibrated micrometer. Account for any finishing allowance where relevant. |
| Length and width | Specify finished dimensions, dimensional tolerances, edge condition, and any cut-outs or processing requirements. | Example stock size: 1,219 × 2,438 mm. Confirm availability and tolerances before ordering; stock sizes are not universal. | Measure the delivered plate and inspect its edges. Record agreed tolerances on the purchase order. |
| Mirror finish quality | Check reflectivity, uniformity, polishing direction or pattern, and whether the finish meets the intended decorative or functional use. | Specify a reference sample and acceptable appearance. Do not assume that a single Ra value defines every “8K” finish. | Inspect the surface under agreed lighting and viewing angles. If roughness is critical, agree on a measurement method and acceptance limit in advance. |
| Flatness and surface condition | Set acceptable limits for waviness, dents, scratches, stains, pits, and other visible defects; clarify whether minor polishing marks are acceptable. | Define flatness and cosmetic acceptance criteria based on the plate dimensions and end use rather than relying on a generic “mirror finish” description. | Inspect the full plate before removing protective film. Use a straightedge or other agreed method for flatness checks. |
| Corrosion and cleaning needs | Match the grade to exposure to moisture, cleaning chemicals, salts, and other corrosive agents. Mirror polishing does not make an unsuitable alloy corrosion-proof. | Choose the grade based on the actual environment; consider 316 for some chloride-exposed applications, subject to a corrosion review. | Review the service conditions and cleaning process with the project specification. Avoid chloride-containing cleaners unless approved for the application. |
| Protective film and traceability | Confirm film type, coverage, removal method, packaging, and traceability from the plate to its material certificate. | Specify protective film suitable for transport and fabrication, plus heat or lot identification and required inspection documents. | Check that film is intact on receipt and that plate markings correspond to the MTC. Test film removal on a sample if adhesive residue is a concern. |