| Resistance value | Nominal resistance, acceptable tolerance, and any resistance change allowed over service life. | 10 kΩ nominal, ±1% initial tolerance. | Confirm the required value is available in the chosen resistor technology and that tolerance includes the circuit’s full error budget. | Specify resistance and tolerance in the applicable product or detail specification; do not assume one tolerance applies to every resistor type. |
| Steady-state power | Normal operating power, overload conditions, duty cycle, and PCB or chassis heat dissipation. | At 100 V across 10 kΩ: P = V²/R = 1 W. | Check rated power at the actual ambient temperature and mounting conditions. Apply the manufacturer’s derating curve; a 50% power target is a common design margin, not a universal standard requirement. | Power rating and derating depend on the resistor’s specified construction and test conditions. Verify them in the relevant detail specification and component data. |
| Working voltage | Maximum continuous voltage across the resistor, including supply tolerance and foreseeable transients. | For a 10 kΩ resistor at 100 V, verify that 100 V is below its specified maximum working voltage. | Check both the maximum working-voltage limit and the power limit. A useful check is V ≤ min(Vmax, √(Pallow × R)); use the part’s specified limits. | Maximum voltage is construction- and size-dependent. IEC 60115-1 does not provide one universal working-voltage value for all fixed resistors. |
| Temperature range | Minimum and maximum operating ambient temperature, resistor temperature rise, and nearby heat sources. | Operating ambient: −40 °C to +105 °C. | Confirm the specified temperature category covers the full operating range and that power derating accounts for the highest ambient temperature. | Temperature category limits are defined for the applicable resistor type and detail specification. Confirm the actual limits rather than inferring them from the general standard. |
| Pulse and overload duty | Pulse voltage, pulse energy, duration, repetition rate, and overload frequency. | Short pulses occur at startup; peak voltage and energy must be calculated from the circuit waveform. | Evaluate pulse-load capability separately from continuous power. Check pulse curves or obtain manufacturer qualification for the required waveform. | Pulse and overload performance should be stated and verified using the applicable component specification and test method. |
| Environment and reliability | Humidity, condensation risk, vibration, mechanical shock, contamination, and expected service life. | Indoor equipment with occasional humidity exposure and moderate vibration. | Define the actual environmental profile and select suitable construction, coating, mounting, and qualification tests. Consider the circuit consequences of drift or an open/short failure. | Environmental tests and acceptance criteria depend on the relevant specification and product class; IEC 60115-1 should not be treated as a substitute for the application’s environmental requirements. |
| Stability and temperature coefficient | Permitted resistance drift over temperature, time, load, and environmental exposure. | Temperature coefficient no greater than ±100 ppm/°C, with a separately defined lifetime drift limit. | Estimate temperature-related change using the specified temperature coefficient, then add initial tolerance, aging, and other drift contributions. | Specify the required performance and test conditions explicitly. Limits and test categories must be confirmed for the selected resistor type. |
| Package and connection | Through-hole or surface-mount format, body size, termination type, mounting method, and available PCB area. | Surface-mount part compatible with the assembly process and required creepage or spacing. | Check footprint, soldering profile, heat flow, mechanical stress, and voltage spacing in the finished assembly. | Dimensions and construction are product-specific. Confirm the drawing and assembly-related limits in the component documentation. |
| Documentation and qualification | Required standard edition, tests, inspection level, traceability, and evidence needed for approval. | Require documented ratings, test conditions, and qualification evidence for the intended application. | Review the complete specification and test reports; verify that ratings apply to the exact resistance, tolerance, size, and construction ordered. | IEC 60115-1 is a generic specification for fixed resistors for use in electronic equipment. Pair it with the applicable sectional or detail specification and the project’s requirements. |