| Nitrile Rubber (NBR) | About −30°C to +100°C (−22°F to +212°F) | Generally suitable for petroleum-based mineral hydraulic oils and many lubricating oils. | Common, economical material with good oil resistance and dependable sealing in many standard hydraulic systems. | Heat, ozone, and weather resistance are limited compared with some alternatives. Usually unsuitable for phosphate-ester fluids; confirm compatibility with the exact fluid formulation. | General-purpose cylinders using mineral-oil hydraulic fluid within moderate temperature limits. |
| Hydrogenated Nitrile Rubber (HNBR) | About −30°C to +150°C (−22°F to +302°F) | Often compatible with petroleum-based mineral oils and selected water-glycol fluids, subject to compound and fluid specifications. | Improved heat, abrasion, and aging resistance compared with standard NBR. | Compatibility is not universal across synthetic fluids or additives. Check the compound supplier’s fluid-compatibility data, especially for water-containing fluids. | Oil-based systems needing greater heat or wear resistance than standard NBR can provide. |
| Fluorocarbon Rubber (FKM) | About −20°C to +200°C (−4°F to +392°F); low-temperature limits vary by grade. | Often suitable for many mineral oils and some synthetic fluids; compatibility depends strongly on fluid chemistry and compound formulation. | Good resistance to elevated temperatures, oils, and many chemicals. | Can be less flexible at low temperatures. Do not assume compatibility with phosphate-ester or other specialty fluids; verify against the exact fluid and seal compound. | Higher-temperature oil service where the fluid and compound compatibility have been confirmed. |
| Polyurethane (PU) | Typically about −30°C to +100°C (−22°F to +212°F), depending on formulation. | Commonly used with mineral hydraulic oils; compatibility with water-based fluids varies by polyurethane type. | High abrasion resistance and good load-bearing capability, making it useful for dynamic cylinder seals. | Some formulations can be vulnerable to hot water, hydrolysis, or prolonged high-temperature exposure. Confirm suitability for the fluid and duty cycle. | Rod and piston seal applications with demanding wear conditions and compatible hydraulic oil. |
| Ethylene Propylene Rubber (EPDM) | About −50°C to +150°C (−58°F to +302°F), depending on formulation. | Often used with phosphate-ester fluids and some water-based fluids. | Good resistance to weathering, ozone, and many water-based fluids. | Generally unsuitable for petroleum-based mineral oils and many hydrocarbon fluids, which can cause swelling or deterioration. | Systems using compatible phosphate-ester or water-based hydraulic fluids—not standard mineral-oil systems. |
| Polytetrafluoroethylene (PTFE) | Material capability is commonly around −200°C to +260°C (−328°F to +500°F); assembly and seal design may impose lower limits. | Broad chemical resistance to many hydraulic fluids, but check the fluid, pressure, and seal design together. | Very low friction and broad chemical resistance; useful in specialized sealing designs. | PTFE has limited elasticity and can deform under sustained load. It is often used as a designed seal element or with an energizer rather than as a simple elastomer replacement. | Specialized low-friction, high-temperature, or chemically demanding applications with an appropriate seal design. |