| Turbine and generator type | Identify the turbine (such as Pelton, Turgo, crossflow, or Francis) and whether the generator is synchronous or induction. | The controller must use a control method compatible with the turbine’s water-control equipment and the generator’s electrical characteristics. | Confirm compatibility with the turbine and generator suppliers before choosing a controller. A system designed for one generator arrangement may not suit another. |
| Electrical operating mode | Determine whether the installation operates as an isolated system or connects to a utility grid. | Isolated systems need to maintain local voltage and frequency as loads change. Grid-connected systems must coordinate with grid protection and interconnection requirements. | Choose controls specifically designed for the intended operating mode. Grid connection requires appropriate protection and compliance with local electrical rules. |
| Load variation | Estimate how quickly and widely consumer demand can change, including sudden load rejection. | An electronic load controller can help regulate frequency in suitable isolated systems by diverting surplus electrical power to a ballast or dump load. | Check that the controller and dump load are rated for the generator output and expected operating conditions. A dump load needs suitable ventilation and thermal protection. |
| Water-flow control | Check whether the turbine has controllable guide vanes, a spear or needle, wicket gates, or another actuator. | A governor can regulate turbine input by adjusting the water-control mechanism, helping match mechanical power to electrical demand. | For turbines with actuated water controls, verify actuator force, travel, response time, and fail-safe behavior with the turbine designer. |
| Control approach | Compare electrical load control with mechanical or electro-hydraulic governing. | Load control manages surplus power electrically; governing changes turbine input. Some installations use coordinated control functions. | Base the choice on plant design, load profile, water-conveyance limits, maintenance skills, and the required response to faults—not on controller type alone. |
| Protection and safety | Review overspeed, overcurrent, overvoltage, under/over-frequency, short-circuit, and emergency-shutdown provisions. | Protection functions help disconnect or reduce output during abnormal conditions. Control equipment does not replace correctly rated electrical protection. | Confirm protective-device coordination, grounding, enclosure rating, and shutdown logic with a qualified electrical engineer. |
| Site conditions | Assess temperature, humidity, dust, vibration, flooding risk, cable runs, and available installation space. | The controller enclosure, sensors, wiring, and actuators must be suitable for the actual installation environment. | Check environmental ratings and mounting requirements. Place control equipment where it can be inspected and serviced while protected from water ingress. |
| Monitoring and maintenance | Decide which readings and alarms operators need, such as voltage, frequency, power, temperature, and fault status. | Useful monitoring supports troubleshooting and helps operators identify changing operating conditions. | Choose a control system with clear indicators, accessible settings, documented wiring, and locally serviceable components. |
| System sizing and verification | Use the generator rating, turbine operating range, expected load, actuator specifications, and site-specific electrical design. | Controller ratings and settings must match the complete hydroelectric system, including sensors, switching devices, and any dump load. | Have final sizing, settings, and commissioning checks completed by qualified professionals. Avoid selecting equipment from generator rating alone. |