| Capacitance and function | Required capacitance, whether the capacitor is used for coupling, timing, filtering, snubbing, or energy storage, and the acceptable change in circuit behavior. | Choose the nominal capacitance and tolerance from the circuit’s calculations. Common film-capacitor tolerances include ±5%, ±10%, and ±20%; availability depends on capacitance and construction. | A timing circuit sensitive to capacitance variation may need a tighter tolerance than a noncritical coupling application. |
| Working voltage | Maximum continuous DC voltage, AC voltage, and any voltage peaks or transients across the capacitor. | Use a voltage rating appropriate to the waveform and operating conditions. AC and DC ratings are not interchangeable; check the manufacturer’s rating definitions and derating curves. | For a capacitor on an AC line or switching node, check the specified AC rating and transient requirements rather than relying only on its DC rating. |
| Current and self-heating | RMS ripple current, current waveform, operating frequency, ambient temperature, and allowable temperature rise. | Verify the part’s permitted RMS current or dissipation at the actual frequency and temperature. Capacitor losses can cause self-heating, and allowable current generally depends on frequency and cooling conditions. | For a switching converter, compare the expected ripple-current spectrum with the datasheet limits over the intended temperature range. |
| Frequency and losses | Signal or switching frequency, pulse shape, and acceptable dissipation or signal loss. | Review capacitance-versus-frequency behavior, dissipation factor, and equivalent series resistance (ESR) where specified. Polypropylene is often selected for low-loss or pulse applications; polyester may suit many general-purpose applications. | In a resonant circuit, check loss and frequency behavior at the operating frequency, not only at a low-frequency test point. |
| Temperature range | Minimum and maximum ambient temperature, nearby heat sources, and the capacitor’s expected internal temperature. | Choose a rated temperature range that covers the actual conditions, and check how capacitance and voltage capability vary with temperature. Temperature limits differ by dielectric, construction, and series. | For equipment in a warm enclosure, allow for both ambient temperature and additional heating from ripple current. |
| Pulse or surge stress | Peak current, pulse duration, repetition rate, voltage rise time (dV/dt), and transient energy. | Confirm the specified pulse-current or dV/dt capability. A voltage rating alone does not establish suitability for repetitive high-current pulses. | For a snubber, calculate the pulse current and repetition rate, then compare them with the capacitor’s pulse and thermal limits. |
| Insulation and leakage | Permitted leakage current, insulation resistance, circuit impedance, and required charge retention. | Check insulation resistance or time-constant specifications at the relevant capacitance and temperature. Leakage performance can vary with value, dielectric, and test conditions. | In a long-time-constant circuit, confirm that capacitor leakage will not cause unacceptable voltage drift. |
| Reliability and failure behavior | Required service life, safety implications, environmental conditions, and consequences of an open or short failure. | Review endurance, humidity, vibration, and applicable safety approvals. Use a safety-rated capacitor in applications where a standard component is not approved for the required mains or across-line use. | For connection across an AC supply, select a capacitor with the required safety classification and approvals for that application. |
| Mechanical fit and assembly | Available board area, lead spacing, body dimensions, mounting method, and assembly process. | Check the full outline dimensions, lead spacing, insulation clearances, and mounting limits. Allow space for tolerances and avoid mechanical stress on the leads or body. | Before layout release, compare the selected part’s drawing with the PCB footprint and enclosure clearance. |