| Commercial building feeder | Distribution board or floor-level panel feeder | Thermal-magnetic or electronic-trip MCCB | Commonly 400/415 V AC in many IEC systems; 480Y/277 V AC in many North American systems | Often 100–630 A, depending on the load and design | Confirm load current, conductor ampacity, available fault current, and coordination with upstream and downstream devices. |
| Industrial motor feeder | Feeder supplying a motor starter or motor control center | MCCB selected for feeder protection, coordinated with the motor starter and overload protection | Commonly 400/415 V or 480 V AC; verify the actual system | Selected from the circuit design; motor full-load current alone does not determine the breaker rating | Account for motor starting current, starting method, conductor protection, and the required coordination or short-circuit protection scheme. |
| Transformer secondary distribution | Main or feeder protection on the low-voltage side of a transformer | MCCB with a trip unit suited to the expected fault level and protection requirements | Commonly 400/415 V or 480 V AC on low-voltage systems | Often 100–1600 A across a range of applications | Calculate or obtain the prospective short-circuit current at the installation point; check the breaker’s rated voltage and interrupting capacity. |
| Generator output circuit | Generator feeder or generator distribution panel | MCCB suitable for the generator’s output and the system’s protection scheme | As specified for the generator and distribution system | Based on generator rating, operating conditions, and circuit design | Check generator fault-current characteristics, neutral and grounding arrangement, and coordination with other protective devices. |
| Capacitor bank feeder | Feeder supplying power-factor correction capacitors | MCCB specifically suitable for capacitor switching duty, used with appropriate switching equipment | As specified for the capacitor bank | Based on capacitor current and the manufacturer’s application guidance | Consider inrush current, harmonic conditions, switching frequency, and any required derating or dedicated protection. |
| Photovoltaic AC distribution | Inverter output feeder on the AC side | AC-rated MCCB selected for the inverter circuit and installation conditions | As specified for the inverter and AC system | Based on inverter output current and applicable design rules | Verify AC voltage and frequency ratings, fault-current contribution, isolation requirements, and applicable local codes. |
| Marine or mobile equipment distribution | Feeder in a vessel, vehicle, or other mobile installation | MCCB with ratings and approvals appropriate to the installation environment | As specified for the onboard or mobile system | Based on the load and system design | Check vibration, temperature, humidity, enclosure requirements, and any required marine or transport approvals. |
| Critical-power distribution | Feeder serving essential loads or a transfer system | MCCB with a suitable electronic trip unit where adjustable protection or monitoring is needed | As specified for the facility | Based on the essential-load schedule and feeder design | Review selectivity, trip settings, remote indication or communications needs, and the consequences of an unwanted trip. |
| Outdoor or harsh-environment installation | Feeder installed in an outdoor or industrial enclosure | MCCB installed in an enclosure with an appropriate environmental rating | As specified for the circuit | Based on the protected load and conductors | Check enclosure protection, ambient-temperature derating, corrosion exposure, and the breaker’s permitted operating conditions. |
| Low-current branch or final circuit | Small branch circuit in a panelboard | Miniature circuit breaker (MCB) may be more appropriate than an MCCB | As specified for the system | Typically lower than many MCCB applications; choose from the circuit design | Do not specify an MCCB by default: confirm the required device category, mounting method, fault rating, and applicable standard. |