| Shrink ratio | Common ratios include 2:1, 3:1, and 4:1. The ratio compares the supplied expanded diameter with the fully recovered diameter. | Determines the range of component sizes the sleeve can fit and how closely it can conform to irregular shapes. | Check that the expanded sleeve fits over the largest part and that its recovered size fits snugly around the smallest part. |
| Recovery temperature | Depends on the polymer and product design. Many polyolefin sleeves begin recovering when heated at roughly 90–150°C; this is a general range, not a universal specification. | Insufficient heat can leave the sleeve loose or only partly recovered. Excessive heat can damage the sleeve, substrate, or nearby components. | Follow the product’s specified recovery temperature and use a controlled heat source. Consider the temperature limits of the component being covered. |
| Operating temperature | Material-specific. Some cross-linked polyolefin products are rated for continuous service around −55°C to +135°C, while other sleeve materials have different limits. | Temperature outside the rated range can cause embrittlement, softening, deformation, or loss of mechanical and electrical performance. | Compare the sleeve’s continuous and short-term temperature ratings with the application’s ambient and peak temperatures. |
| Recovered wall thickness | Varies by sleeve size, shrink ratio, and construction. Adhesive-lined sleeves have an inner adhesive layer in addition to the outer wall. | Wall thickness contributes to abrasion protection, insulation, and resistance to handling damage. | Use the specified recovered-wall measurement when comparing products; supplied expanded thickness alone does not describe the installed wall. |
| Longitudinal shrinkage | Some sleeves shorten during recovery. The amount varies by material and product construction. | Length change can expose part of a joint or shift the sleeve away from the intended coverage area. | Allow for possible end movement and confirm the specified longitudinal change when coverage length is critical. |
| Material and flexibility | Common sleeve materials include polyolefin, PVC, fluoropolymers, and elastomeric materials. Their flexibility, temperature limits, and chemical resistance differ. | The material determines how the sleeve behaves around bends and under heat, chemicals, moisture, and mechanical stress. | Match the material to the environment and installation geometry rather than selecting by shrink ratio alone. |
| Adhesive lining | Available in some constructions; the inner adhesive softens during heating and can flow to fill gaps as the sleeve recovers. | Can improve bonding and help seal against moisture or contaminants when correctly selected and installed. | Confirm compatibility with the substrate and follow the specified heating process. A sleeve is not automatically waterproof just because it is adhesive-lined. |
| Electrical insulation | Electrical performance is product-specific and should be stated in the applicable technical specification or test standard. | Insulation capability affects suitability for covering wires, connections, or other energized components. | Check the rated voltage, dielectric properties, wall thickness, and applicable safety requirements for the intended use. |
| Flame behavior | Flame-retardant and non-flame-retardant versions are available; performance depends on the formulation and test method. | Can be important where fire behavior is controlled by equipment or installation requirements. | Verify the specific flame rating and test standard. Do not infer flame performance from the sleeve’s appearance or base material alone. |
| Chemical and weather resistance | Resistance varies with the polymer, chemical, exposure time, temperature, and ultraviolet exposure. | Unsuitable exposure can lead to swelling, cracking, discoloration, or reduced mechanical strength. | Check compatibility against the actual chemicals and outdoor conditions expected in service. |