| Cellulose | Paper-like fibers formed into a porous web; may be supplied as a flat roll or supported with a scrim. | Can provide economical particulate capture. Performance depends on fiber structure, media thickness, and any treatment applied. | Initial resistance varies by grade and airflow. Dust accumulation increases resistance, so changeout is commonly based on pressure drop or a maintenance limit. | Untreated cellulose can lose strength or become damaged when exposed to excessive moisture. Check compatibility with humidity, temperature, and process contaminants. | General ventilation, prefiltration, and selected dry-process applications. |
| Synthetic polyester | Nonwoven polyester fibers, often thermally bonded or mechanically entangled; available in different thicknesses and fiber densities. | Provides depth loading, with particles captured through the media structure. Some grades are washable or reusable when specifically designed and approved for that purpose. | Loft and density influence both dust-holding capacity and resistance. A more open structure may allow higher airflow but may capture fewer fine particles. | Often more tolerant of humid conditions than untreated cellulose, but temperature and chemical resistance depend on the fiber grade and binder or finish. | Ventilation systems, equipment intake filters, and general industrial air filtration. |
| Cellulose–polyester blend | Combined natural and synthetic fibers, designed to balance cost, handling strength, and filtration behavior. | Properties vary with the blend ratio and web construction. The synthetic component can improve strength, while cellulose contributes to the media structure. | Airflow resistance and dust capacity are grade-specific; compare published performance data for the intended face velocity and loading conditions. | Moisture tolerance is not determined by the blend alone. Confirm the effects of humidity, condensate, and process chemicals with the supplier’s technical data. | General-purpose filtration where a balance of performance and material cost is needed. |
| Fiberglass | Fine glass fibers arranged in a web; some roll products use progressively denser layers or a reinforcing backing. | Fine fibers can support efficient particle capture in suitable grades. Media structure and fiber diameter affect efficiency and resistance. | Higher capture efficiency can be accompanied by greater resistance, depending on the grade and operating conditions. Correct sizing helps avoid excessive face velocity. | Use within the manufacturer’s specified temperature range and follow handling guidance to prevent fiber release or damage during installation and service. | Selected HVAC and industrial air-filtration stages, including applications requiring fine-particle capture. |
| Progressive-density media | A layered or graded web with a more open upstream face and a denser downstream region; it may be made from synthetic or blended fibers. | Uses media depth to distribute particle capture through more of the material rather than concentrating it only at the surface. | Can support useful dust-holding capacity, but actual service life and pressure-drop development depend on dust type, concentration, airflow, and media grade. | Layer integrity and any binder or backing must suit the operating environment. Inspect for damage, bypass, or uneven loading. | Panel-filter cut-to-size applications and prefiltration in industrial ventilation systems. |
| Tackified roll media | Fibrous media treated with an adhesive or tackifying finish to help retain captured particles. | The tacky surface can improve retention of collected dust and reduce particle release under suitable conditions; it does not replace a specified efficiency rating. | Surface loading and dust buildup can raise resistance. Replace the media according to the equipment’s pressure-drop limits and maintenance procedure. | Finish performance can be affected by temperature, moisture, and chemical exposure. Confirm compatibility before use. | Paint-booth intake filtration and other applications where retaining airborne overspray or dust is required. |