| 1 | Match the coating to the laser wavelength. High-reflecting (HR), anti-reflection (AR), and other dielectric coatings are designed for particular wavelength regions. | Operating wavelength or wavelength range, including any relevant bandwidth and expected wavelength drift. | A coating designed for one wavelength is not automatically suitable for another. For example, a narrowband coating centered near 1064 nm may not perform as intended at 1030 nm. Request performance data across the actual operating range. |
| 2 | Choose the film function. HR coatings return light; AR coatings reduce surface reflection; dichroic coatings reflect one band and transmit another; beamsplitter coatings divide incident power. | Required reflectance and transmittance, the relevant wavelength bands, and whether the optic is used in reflection, transmission, or both. | As design targets, an HR mirror may specify reflectance above 99%, while an AR coating may target residual reflection below 0.5% per coated surface at its design wavelength. These are examples, not guaranteed values; confirm the full specification and measurement conditions. |
| 3 | Check laser-induced damage resistance. The coating and substrate together must tolerate the beam’s peak intensity or fluence. | Continuous-wave or pulsed operation, wavelength, pulse duration, repetition rate, beam size, and the required laser-induced damage threshold (LIDT). | Compare LIDT results only when the test wavelength, pulse duration, repetition rate, beam conditions, and test method are relevant to your application. A damage-threshold value measured under different conditions may not predict performance in your system. |
| 4 | Account for angle of incidence and polarization. Coating response can shift or change with incidence angle and with s- or p-polarized light. | Operating angle, angle tolerance, and polarization state (unpolarized, s-polarized, or p-polarized). | Normal-incidence data may not describe an optic used at 45°. For angled use, request reflectance and transmittance data at the actual angle and for the required polarization; specify separate s- and p-polarization targets if needed. |
| 5 | Select a suitable substrate and surface. The film is deposited on an optical substrate, whose material and surface quality affect system performance. | Substrate material, diameter or dimensions, thickness, surface flatness, surface quality, and coated surface or surfaces. | Confirm that the substrate transmits the operating wavelength and meets thermal and mechanical requirements. Also check whether the optic needs one coated surface or both; uncoated surfaces can add reflection and ghost beams. |
| 6 | Consider the operating environment. Protective and durable coating designs can help an optic withstand handling, humidity, temperature changes, and cleaning. | Operating temperature range, humidity exposure, vacuum or other environmental conditions, and cleaning requirements. | Ask for environmental durability data relevant to the intended use. Do not assume that a coating is suitable for frequent contact cleaning or harsh environments solely because it is described as durable. |
| 7 | Review the complete specification and test data. Performance depends on the finished optic, not just the coating category. | Acceptance tolerances, spectral curves, uniformity, coating location, inspection method, and LIDT test conditions where applicable. | Request measured or guaranteed performance over the required wavelength, angle, and polarization ranges. Check whether stated reflectance or transmittance applies to the coated surface, the complete optic, or a specified test setup. |