| 1 | Cavity Insert | Forms the external surfaces of the molded part, including its visible faces and outer details. | Usually installed in the stationary half of the mold. | Surface finish, shrinkage allowance, cooling, and replaceability should suit the part and production volume. |
| 2 | Core Insert | Forms internal surfaces, openings, recesses, and other details on the inside of the part. | Often located in the moving half; may be designed as a separate replaceable insert. | Draft, strength, cooling, and resistance to wear matter, especially for slender core features. |
| 3 | Mold Base and Plates | Supports and aligns the mold assembly, while holding inserts, guiding components, and ejection hardware. | Forms the structural frame of the stationary and moving mold halves. | Plate stiffness, adequate support, machine mounting, and access for cooling and maintenance are important. |
| 4 | Sprue Bushing | Directs molten plastic from the machine nozzle into the mold’s runner system or cavity. | Mounted in the stationary half, aligned with the injection machine nozzle. | Nozzle-seat fit, flow path, sealing, and removal of the solidified sprue should be considered. |
| 5 | Locating Ring | Positions the mold accurately relative to the injection machine’s platen and nozzle. | Attached to the stationary side of the mold. | Its dimensions must match the machine interface and keep the sprue bushing aligned with the nozzle. |
| 6 | Leader Pins and Bushings | Guide the two mold halves into alignment as the mold closes. | Installed between the stationary and moving halves, typically around the mold perimeter. | Correct clearance, alignment, lubrication, and protection from contamination help reduce wear and damage. |
| 7 | Ejector Pins | Push the cooled part off the core after the mold opens. | Move through the ejector plate and bear on selected areas of the part. | Pin locations and contact areas should limit visible marks, part distortion, and sticking. |
| 8 | Runner System | Carries molten plastic from the sprue to one or more gates in a cold-runner mold. | Formed in channels between mold plates, leading to the cavity or cavities. | Channel size and layout affect filling, pressure loss, material use, and runner removal. |
| 9 | Cooling Channels | Circulate a cooling fluid to remove heat from the mold and help control cycle time and part quality. | Drilled or formed within mold plates and near the cavity and core surfaces. | Channel position and flow should promote even cooling without weakening the mold or causing leaks. |
| 10 | Vents | Allow trapped air and gases to escape as molten plastic fills the cavity. | Often placed near the end of the fill path, parting line, or other air-trap locations. | Vent depth must suit the resin and process: vents should release gas while limiting plastic flash. |