| Isolation rating | Rated isolation voltage, transient withstand voltage, and the test conditions stated in the datasheet. | Check the exact part number’s datasheet and safety certificate; do not treat a short-duration withstand rating as a continuous working-voltage rating. | Helps determine whether the device is appropriate for the system’s insulation and safety requirements. |
| Common-mode transient immunity | Specified CMTI value, test voltage, and test conditions. | Compare devices using the same units and test conditions. Confirm performance at the intended supply voltage and operating temperature. | Higher CMTI can help preserve signal integrity when fast voltage transients occur across the isolation barrier. |
| Data rate and timing | Maximum data rate, propagation delay, pulse-width distortion, and channel-to-channel matching. | Review timing specifications for the required communication protocol and check whether limits apply across the full operating range. | These parameters affect timing margins in digital interfaces, control loops, and clock or data paths. |
| Channel configuration | Number of channels and direction combinations, such as one-way or bidirectional channel arrangements. | Match the channel arrangement to the signal flow in the circuit and confirm the pinout in the package drawing. | Suitable channel configuration can reduce board space and simplify signal routing. |
| Power and logic compatibility | Supply-voltage range, logic thresholds, and input/output behavior during power-up or loss of supply. | Check compatibility with the host controller and review the truth table, recommended operating conditions, and application circuit. | Supports reliable logic-level translation and predictable system behavior. |
| Operating environment | Specified operating-temperature range and relevant electrical limits over temperature. | Confirm that the rated range covers the application’s ambient and board-level thermal conditions. | Temperature can affect timing, power consumption, and electrical performance. |
| Safety documentation | Applicable approvals and the scope of each certificate, including the exact device variant. | Verify certificate records and conditions directly; IEC 60747-17, UL 1577, and VDE 0884-11 are examples of standards or approval frameworks relevant to isolation components. | Certification requirements depend on the end product, insulation system, and target market. |
| Package and board layout | Package outline, creepage and clearance dimensions, pin spacing, and recommended PCB layout. | Use the manufacturer’s mechanical drawing and layout guidance; assess spacing in the context of the applicable end-product requirements. | PCB geometry and installation conditions influence the insulation design of the complete assembly. |
| Reliability and quality controls | Qualification information, production traceability, change-control practices, and failure-analysis support. | Request current quality documentation and confirm the scope, revision, and applicability to the specific product family. | Provides evidence for supply-chain assessment and long-term product qualification. |
| Technical and supply support | Availability of complete datasheets, application notes, samples, lifecycle notices, and engineering support. | Evaluate response quality and documentation consistency during sample review and design-in. | Clear documentation and support help reduce design and procurement risks. |