| Specific surface area | Often approximately 800–1,200 m²/g for high-surface-area activated carbon; the result depends on the carbon grade and test method. | Provides a broad indication of available adsorption surface, but does not by itself predict PSA working capacity or separation performance. | Request the test method, recent lot data, and performance data under conditions relevant to the intended gas mixture. |
| Iodine number | Commonly used as a comparative quality indicator; values around 800–1,100 mg/g are seen for many activated-carbon grades. | Can help compare batches of similar carbon, but is not a direct measure of PSA capacity for every target gas. | Confirm the applicable test method and treat the value as a screening measure rather than a substitute for gas-adsorption testing. |
| Bulk density | Many granular or pelletized grades fall broadly around 400–550 kg/m³; actual values vary with form, particle size, and measurement procedure. | Affects the mass of adsorbent loaded into a vessel and can influence bed design and pressure drop. | Check whether the figure is loose or tapped bulk density and compare samples using the same procedure. |
| Moisture content | Low moisture is generally preferred; some commercial specifications set a maximum near 5% by mass. | Water can occupy adsorption sites and affect usable capacity, especially where feed gas moisture is not adequately controlled. | Confirm the measurement basis, packaging conditions, and moisture-control requirements for storage and loading. |
| Ash content | Grade-dependent; a stated maximum of about 10% by mass is a useful screening reference, not a universal PSA requirement. | Mineral residue can affect purity, surface characteristics, and consistency between production lots. | Request the test method, typical value, maximum limit, and relevant contaminant information. |
| Particle size and form | Granules or pellets are used; particle sizes around 1.5–4 mm are common in some packed-bed applications. | Particle size affects pressure drop, mass transfer, packing, and resistance to particle movement in a cyclic bed. | Specify the nominal size range, undersize and oversize limits, shape, and sieve-analysis method. |
| Mechanical strength and attrition | Should be evaluated using a test appropriate to the supplied particle form; there is no single comparable value across all test methods. | Durable particles help limit fines, pressure-drop increase, and adsorbent loss during repeated pressurization and depressurization. | Request the test method and results for hardness, crush strength, or attrition, as applicable to the product form. |
| Pore structure | Micropore and mesopore distribution is grade-specific and should be described with measured data rather than surface area alone. | Pore structure influences adsorption behavior and how quickly target components can enter and leave the particles during PSA cycling. | Ask for pore-size or pore-volume data and, where possible, adsorption isotherms for relevant gases. |
| Gas-specific adsorption performance | Depends on the gas composition, pressure, temperature, humidity, and cycle conditions; no single capacity value applies to every PSA unit. | Directly informs working capacity, selectivity, and the achievable product purity and recovery. | Request test data under conditions close to the intended process and confirm whether the data are equilibrium or dynamic measurements. |
| Application fit | Activated carbon may be used for selected PSA duties, such as removing certain impurities in gas-purification trains. It is distinct from carbon molecular sieve (CMS). | CMS is commonly used in PSA nitrogen generators; activated carbon and CMS have different adsorption characteristics and are not interchangeable by default. | Confirm the intended gas service, bed position, pretreatment needs, and compatibility with the process design before selection. |
| Quality documentation and consistency | Lot-specific certificates of analysis, defined acceptance limits, and traceable sampling are useful procurement controls. | Consistent properties support predictable bed loading and operation across replacement batches. | Review the certificate of analysis, quality-control methods, packaging, storage guidance, and change-notification practices. |