| Automotive and industrial cooling | Water and water-glycol coolant mixtures | Reinforced silicone coolant hose | Coolant formulation, operating temperature, system pressure, hose inside diameter, and bend radius | Check the hose datasheet for the permitted coolant types, continuous and peak temperature limits, pressure rating at the intended temperature, and applicable dimensional requirements. | Do not assume compatibility with every coolant additive or cleaning chemical; verify the exact fluid formulation with the hose supplier. |
| Turbocharger and charge-air plumbing | Compressed air; possible traces of oil mist | Reinforced charge-air silicone hose, with suitable liner if specified | Boost pressure, under-hood temperature, vacuum exposure, vibration, and fitting retention | Confirm pressure and vacuum ratings for the exact size and reinforcement, along with temperature limits and the manufacturer’s guidance on oil exposure. | Silicone is generally not intended for continuous contact with petroleum fuels or oils. Oil mist tolerance is product-specific and is not equivalent to immersion compatibility. |
| Food and beverage transfer | Water, selected beverages, or food-contact fluids | Food-contact silicone hose with suitable reinforcement and documented formulation | Fluid composition, temperature, cleaning and sanitizing cycle, pressure, and whether the hose is used for repeated or single-use contact | Request current compliance documentation for the exact hose construction and intended market. Check applicable requirements, such as FDA 21 CFR 177.2600 or relevant EU food-contact rules, where claimed. | A general-purpose silicone hose is not automatically suitable for food contact. Compliance depends on the complete hose construction and conditions of use. |
| Pharmaceutical or bioprocess equipment | Process fluids, purified water, or cleaning solutions | Documented process-grade silicone hose selected for the fluid and cleaning regime | Fluid chemistry, sterilization method, temperature, pressure, extractables requirements, and service life | Review product-specific declarations, traceability, validation information, and sterilization compatibility; confirm that the documentation covers the finished hose assembly if applicable. | “Pharmaceutical grade” is not a substitute for checking the exact formulation, regulatory documentation, and process conditions. |
| Hot-air ducting and equipment vents | Hot air or non-reactive gases | Heat-resistant reinforced silicone hose or silicone-coated fabric duct, as appropriate | Continuous and intermittent temperatures, airflow, external heat, abrasion, and any pressure or vacuum load | Check whether the published temperature limit applies continuously or only intermittently, and confirm the pressure or vacuum rating for the selected construction. | Temperature capability varies by formulation and construction. A temperature rating alone does not establish pressure, vacuum, or chemical suitability. |
| Fuel, lubricant, or hydraulic-fluid lines | Gasoline, diesel, petroleum oils, or hydraulic fluids | Use a hose specifically designed and rated for the exact fuel or oil, rather than selecting silicone by temperature rating alone | Fluid type and additives, pressure, permeation limits, temperature, and relevant industry or vehicle requirements | Require explicit written compatibility and application ratings for the exact fluid and hose construction; verify any required fuel, emissions, or safety standards. | General-purpose silicone is typically unsuitable for continuous petroleum-fuel or oil service unless the specific product documentation expressly states otherwise. |
| Outdoor or mobile equipment connections | Air or compatible coolant, depending on the system | UV- and weather-resistant reinforced silicone hose, if specified for the service | Sunlight, ozone, vibration, abrasion, temperature cycling, pressure, and connector movement | Confirm environmental resistance, reinforcement material, bend radius, clamp or fitting requirements, and inspection or replacement guidance. | Environmental resistance does not guarantee compatibility with the conveyed fluid or suitability for a particular pressure and temperature combination. |