| Handheld overall vibration meter | Velocity: approximately 0.1–100 mm/s RMS; frequency commonly 10–1,000 Hz | Typically about ±5% of reading under stated operating and calibration conditions | Routine checks on motors, pumps, fans, and gearboxes; quick screening against site alarm limits | Fast and portable, but overall readings provide limited information for diagnosing specific faults. |
| Portable FFT vibration analyzer | Frequency bandwidth commonly extends from below 1 Hz to several kHz; some configurations reach 20 kHz | Amplitude accuracy is often specified around ±5% of reading; confirm the analyzer, sensor, and setup specifications | Fault diagnosis, spectrum analysis, bearing and gear evaluation, and troubleshooting unexpected vibration | Offers detailed frequency information; results depend on sensor mounting, sampling settings, and measurement technique. |
| Route-based data collector | Typical route measurements cover machine vibration from low frequencies to several kHz, depending on the sensor and collection setup | Commonly comparable to portable analyzer systems; accuracy is specified for the complete measurement chain | Scheduled condition-monitoring rounds across many machines and comparison of readings over time | Supports repeatable, organized surveys; consistent measurement locations and operating conditions are essential. |
| Online vibration monitoring system | Sensor-dependent; industrial accelerometer channels commonly monitor from sub-hertz frequencies to several kHz | System accuracy varies with the sensor, signal conditioner, installation, and calibration; verify the complete-channel specification | Continuous monitoring of critical or hard-to-access equipment, trend alarms, and condition-based maintenance | Provides continuous trends and alerts, but requires appropriate sensor placement, installation, and alarm configuration. |
| Industrial piezoelectric accelerometer | Common configurations measure up to tens of g; usable frequency range may extend from around 0.5 Hz to 10 kHz or higher | Sensitivity tolerance is often specified separately, commonly around ±5%; this is not the same as total system accuracy | Permanent or portable measurements of machine acceleration, including bearing and higher-frequency vibration | Requires suitable mounting and compatible signal conditioning; select range and frequency response for the machine and task. |