| Induction motors operating below rated load | Often lower at light load; varies by motor and operating point | Motors draw magnetizing current even when producing relatively little mechanical output. | Higher reactive-current demand and increased current in cables and transformers. | Review motor sizing and operating schedules; consider appropriately controlled capacitor compensation. |
| Motors, pumps, and fans started directly across the line | Low during starting; running power factor depends on load | Starting current can be several times normal current, while the motor is not yet delivering full mechanical output. | Short-duration voltage dips and higher demand on the electrical distribution system. | Assess starting methods and system capacity; use soft starters or variable-frequency drives where technically suitable. |
| Transformers operating with light loads | Can be relatively low at light loading | Transformer magnetizing current remains present even when the useful load is small. | Unnecessary reactive-power demand and less efficient use of the transformer capacity. | Review transformer loading and operating configuration; avoid energizing redundant units where operational requirements permit. |
| Welding equipment and arc furnaces | May be low and fluctuate with the process | Arc characteristics and rapidly changing loads can create variable reactive-power demand. | Fluctuating current and, in some installations, voltage variation or flicker. | Measure the load profile and assess fast-response compensation or other power-quality solutions. |
| Induction heating and other inductive process equipment | May be low without local compensation | Inductive equipment requires reactive power to establish its magnetic field. | Greater apparent-power demand for the same useful real-power output. | Use equipment-specific compensation designed for the operating frequency and load characteristics. |
| Fluorescent lighting with magnetic ballasts | Can be lower than lighting systems with suitable electronic drivers | Magnetic ballasts are inductive and can draw reactive current. | Additional current in lighting circuits and distribution equipment. | Evaluate ballast correction or suitable lighting upgrades, considering compatibility and harmonic performance. |
| Variable-frequency drives and electronic power converters | Displacement power factor may be high, but total power factor can be reduced by distortion | Nonlinear current waveforms can introduce harmonics; capacitor banks alone may not address the issue. | Potential overheating, interference, or resonance concerns if mitigation is poorly selected. | Measure harmonics and total power factor; assess line reactors, harmonic filters, or drive-specific solutions. |
| Large capacitor banks switched in fixed steps | Can cause leading power factor during light-load periods | Fixed compensation may exceed the facility's reactive-power requirement when loads decrease. | Possible overvoltage, control issues, or penalties where leading power factor is restricted. | Use automatic stepped control and verify settings against measured load conditions and utility requirements. |
| Long, lightly loaded production shifts or seasonal shutdowns | May worsen overall power factor as the load mix changes | Fixed inductive loads, such as transformers and motors, can remain energized while useful production load falls. | Lower utilization of electrical capacity and potentially higher billed demand or reactive-energy charges. | Track power factor by shift and operating mode; coordinate equipment shutdowns and compensation controls. |